Sculpt Room — now shipping
Speakers cast in one piece, voiced against one curve, and built so every part that wears out is a part you can replace yourself.
Listening level
Drag the control, or focus it and use the arrow keys. It is a demonstration of the physical UI, not a volume control — nothing on this page plays audio.
The idea
Most speakers are a box with a grille, designed to be ignored. We wanted the opposite: something with weight and a surface worth touching, that also happens to measure well.
The soft shapes are not decoration. A cast enclosure with no parallel walls and no panel joins is quieter than an assembled one, and it happens to look like something you would keep.
One acoustic voicing across every product
Every wearing part replaceable with a screwdriver
Correction measured in your room, not assumed
Ten years of spare parts after a model retires
The range
Buy one and it works alone. Buy another and the Hub makes them one system, delay-matched and voiced identically.
Bookshelf
£690
The reference of the range. A two-way sealed cabinet that disappears into a shelf and stops behaving like furniture the moment it plays.
Floorstanding
£1,480
The same voicing with the low end intact. A ported column tuned to sit near a wall, because that is where people actually put them.
Headphones
£420
Open-backed, voiced to the same curve as the speakers, so mixing on one and listening on the other agree with each other.
Source
£340
The thing everything else connects to. Roon-ready, AirPlay 2, and a physical volume wheel because a phone is a bad remote.
Why it sounds like this
Nothing here is exotic. It is the set of decisions you make when the cabinet is cast rather than assembled and every driver has its own amplifier.
Six microphones sweep the room on setup and again whenever the Hub notices the response has drifted. Correction is applied in the analogue domain, after the DAC.
±1.5dBin-room deviation, 100Hz–10kHz
Cast in a mineral composite rather than assembled from panels, so there is no seam to buzz and no internal standing wave to damp out afterwards.
0panel joints in the enclosure
Each driver gets its own amplifier and its own filter, which removes the passive crossover and the phase error that comes with it.
3independent amplifier channels
Speakers talk to the Hub on a dedicated 5GHz link rather than Bluetooth, so the signal that reaches the driver is the one that left the source.
24/192wireless, uncompressed
Under half a watt asleep, and it actually sleeps: no listener, no telemetry, no keeping the network awake.
0.4Wmeasured standby draw
Eight screws to the driver, four to the amplifier board. Both are stocked as spare parts for ten years from the day a model is discontinued.
10yrspare-part commitment
Questions
Contact
Dimensions, what is on the floor, and where you would like them to go. We will tell you which pair, or that you do not need the bigger one.
Support
help@sculptaudio.com
Listening room
By appointment, Copenhagen
Phone
+45 33 12 88 40
Spares
parts.sculptaudio.com